Summer Special Sale - Limited Time 60% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 575363r9

Welcome To DumpsPedia

HPE6-A79 Sample Questions Answers

Questions 4

A network administrator has racked up a 7210 Mobility Controller (MC) that will be terminating 200+ Aps on a medium-size branch office. Next, the technician cabled the appliance with 4SPF+ Direct Attached Cables (DACs) distributed between two-member switching stack and powered it up.

What must the administrator do next in the MCs to assure maximum wired bandwidth utilization?

Options:

A.

Map the four physical ports to port channel 0.

B.

Disable spanning tree and allocate unique VLANs to each port.

C.

Manually set 10Gbps speeds on all ports.

D.

Configure the same MSTP region that the switches have.

E.

Make all ports trunk interfaces and permit data VLANs.

Buy Now
Questions 5

Refer to the exhibits.

A network administrator deploys User Based Tunneling (UBT) in a corporate network to unify the security policies enforcement. When users authenticate with 802.1X, ClearPass shows Accept results, and sends the Aruba-User-Role attribute as expected. However, the AOS-CX based switch does not seem to build the tunnel to the Mobility Controller (MC) for this user.

Why does the switch fail to run UBT for the user?

Options:

A.

The switch has not fully associated to the MC.

B.

ClearPass is sending the wrong Vendor ID.

C.

The switch is not configured with the gateway-role.

D.

ClearPass is sending the wrong VSA type.

E.

The switch is not configured with the port-access role.

Buy Now
Questions 6

A customer wants a WLAN solution that permits Aps to terminate WPA-2 encrypted traffic from different SSIDs to different geographic locations where non-related IT departments will take care of enforcing security policies. A key requirement is to minimize network congestion, overhead, and delay while providing data privacy from the client to the security policy enforcement point. Therefore, the solution must use the shortest path from source to destination.

Which Aruba feature best accommodates this scenario?

Options:

A.

Inter MC S2S IPsec tunnels

B.

RAPs

C.

Multizone Aps

D.

VIA

E.

Inter MC GRE tunnels

Buy Now
Questions 7

Refer to the exhibit.

A network administrator has Mobility Master (MM) - Mobility Controller (MC) based network and has fully integrated the MCs with ClearPass for RADIUS-based AAA services. The administrator is testing different ways to run user role derivation.

Based on the show command output, what method has the administrator use for assigning the “corp” role to client with MAC xx:xx:xx:xx:xx:xx?

Options:

A.

Dynamic Authorization using VSA attributes.

B.

Dynamic Authorization using IETF attributes.

C.

Server Derivation Rules using IETF attributes.

D.

User Derivation Rules using the client's MAC.

Buy Now
Questions 8

A company with 50 small coffee shops in a single country requires a single mobility solution that solves connectivity needs at both the main office and branch locations. Coffee shops must be provisioned with local WiFi internet access for customers.

The shops must also have a private WLAN that offers communication to resources at the main office to upload sales, request supplies through a computer system, and make phone calls if needed. In order to simplify network operations, network devices at the coffee shops should be cloud managed.

Which technologies best meet the company needs at the lowest cost?

Options:

A.

IAPVPN

B.

SD-Branch

C.

Activate with RAPs

D.

BOC with CAPs

Buy Now
Questions 9

A network administrator has deployed an Airwave Management Platform (AMP) server and integrated it with a Mobility Master (MM) – Mobility Controller (MC) based WLAN. The AMP server already has all Aruba Mobility devices including Access Points (APs) in the “UP” devices list.

What are two actions the administrator can execute upon the APs under “Airwave>Devices>Monitor”? (Choose two.)

Options:

A.

Open the WebUI of the MC where the AP terminates.

B.

Re-provision the Access Point.

C.

Disable and change the mode of the AP's radios.

D.

Invoke MC's show commands for that Access Point.

E.

Run Spectrum Analysis locally.

Buy Now
Questions 10

Refer to the exhibits.

Exhibit 1

Exhibit 2

Exhibit 3

A network administrator wants to allow contractors to access the corporate WLAN named EmployeesNet with the contractor role in VLAN 40. When users connect, they do not seem to get an IP address. After some verification checks, the network administrator confirms the DHCP server (10.254.1.21) is reachable from the Mobility Controller (MC) and obtains the outputs shown in the exhibits.

What should the network administrator do next to troubleshoot this problem?

Options:

A.

Permit UDP67 to the contractor role.

B.

Remove the IP address in VLAN 40.

C.

Configure the DHCP helper address.

D.

Confirm there is an IP pool for VLAN 40.

Buy Now
Questions 11

A network administrator is in charge of a Mobility Master (MM) – Mobility Controller (MC) based network security. Recently the Air Monitors detected a Rogue AP in the network and the administrator wants to enable “Tarpit” based wireless containment.

What profile must the administrator enable “tarpit” wireless containment on?

Options:

A.

IDS Unauthorized device profile

B.

IDS profile

C.

IDS General profile

D.

IDS DOS profile

Buy Now
Questions 12

An organization has several RAPs at different locations that broadcast two SSIDs. The internet-only SSID is in bridge/always mode, and the corporate SSID is in split-tunneling/standard mode. The network administrator deploys 10 more RAPs in different locations.

Users can successfully connect to the corporate SSID that is propagated by a RAP at a remote location. However, they report that it takes too long to access public internet web sites.

What is one part of the configuration that should be checked by the network administrator to verify this RAP deployment?

Options:

A.

User roles policies

B.

IP pool

C.

Operating mode

D.

Assigned VLAN

Buy Now
Questions 13

Refer to the exhibit.

A network administrator wants to configure an 802.1x supplicant for a wireless network that includes the following:

• AES encryption

• EAP-MSCHAP v2-based user and machine authentication

• Validation of server certificate in Microsoft Windows 10

The network administrator creates a WLAN profile and selects the change connection settings option. Then the network administrator changes the security type to Microsoft: Protected EAP (PEAP), and enables user and machine authentication under Additional Settings.

What must the network administrator do next to accomplish the task?

Options:

A.

Change default RC4 encryption for AES.

B.

Enable user authentication under Settings

C.

Change the security type to Microsoft: Smart Card or other certificate.

D.

Enable server certificate validation under Settings.

Buy Now
Questions 14

A software development company has 764 employees who work from home. The company also has small offices located in different cities throughout the world. During working hours, they use RAPs to connect to a datacenter to upload software code as well as interact with databases.

In the past two month, cabling issues have occurred connection to the 7240XM Mobility Controller (MC) that runs ArubaOS 8 and terminates the RAPs. These RAPs disconnect, affecting the users connected to the RAPs. This also causes problems with code uploads and database synchronizations. Therefore, the company decides to add a second 7240XM controller for redundancy.

How should the network administrator deploy both controllers in order to provide the redundancy while preventing failover events from disconnecting users?

Options:

A.

Connect both controllers with common VLANs. and create an HA fast failover group with public addresses in the internet VLAN.

B.

Connect both controllers with common VLANs. and create an L2-connected cluster using public addresses in the internet VLAN.

C.

Connect both controllers with different VLANs. and create an L2-connected cluster using public addresses in the internet VLAN.

D.

Connect both controllers with common VLANs. and configure LMS/BLMS values equal to public addresses in the internet VLAN.

Buy Now
Questions 15

A network administrator has updated the ArubaOS code of a standalone Mobility Controller (MC) that is used for User-Based Tunneling (UBT) to a newer early release. Ever since the MC seems to reject PAPI sessions from the switch with the 10.1.10.10 IP address. Also the controller’s prompt is now followed by a star mark: “(MC_VA) [mynode] *#”

When opening a support ticket, an Aruba TAC engineer asks the administrator to gather the crash logs and if possible replicate UBT connection attempts from the switch while running packet captures of PAPI traffic on the controller and obtain the PCAP files. The administrator has a PC with Wireshark and TFTP server using the 10.0.20.20 IP address.

What commands must the administrator issue to accomplish these requests? (Choose two.)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

E.

Option E

Buy Now
Questions 16

An organization owns a fully functional multi-controller Aruba network with a Virtual Mobility Master (VMM) in VLAN20. They have asked a network consultant to deploy a redundant MM on a different server. The solution must offer the lowest convergence time and require no human interaction in case of failure.

The servers host other virtual machines and are connected to different switches that implement ACLs to protect them. The organization grants the network consultant access to the servers only, and appoints a network administrator to assist with the deployment.

What must the network administrator do so the network consultant can successfully deploy the solution? (Choose two.)

Options:

A.

Allocate VLAN20 to the second server, and extend it throughout the switches, then reserve one IP address for the second MM and another IP address for its gateway.

B.

B. Allocate VLAN20 to the second server, and permit routing between them, then reserve one IP address for the second MM and another IP address for its gateway.

C.

Configure an ACL entry that permits IP protocol 50, UDP port 500, and multicast IP 224.0.0.18.

D.

Allocate VLAN20 to the second server, and extend it throughout the switches, then reserve one IP address for the second MM and another for the VIP.

E.

Configure an ACL entry that permits UDP 500, TCP 4500, and multicast IP 224.0.0.5.

Buy Now
Exam Code: HPE6-A79
Exam Name: Aruba Certified Mobility Expert Written Exam
Last Update: May 17, 2024
Questions: 55
$64  $159.99
$48  $119.99
$40  $99.99
buy now HPE6-A79