VCS-272 Sample Questions Answers

Which command should an administrator run to display all images written to both disk and tape for a particular client?

Which two conditions must be met to change the volume group of a tape? (Select two.)

A tape library had the robot firmware upgraded and now the robot is reading the barcodes with additional characters.

How should an administrator enable NetBackup 7.6.1 to use the same characters as before the firmware upgrade occurred?

An administrator has a backup policy with the following policy attributes:

3 paths listed in the Backup Selections list

5 clients listed in the Clients list

Allow multiple data streams is selected

Limit Jobs per policy is set to 4

How many jobs go Active when the job is started, excluding parent jobs?

An administrator has a backup policy with the following attributes:

5 paths listed in the Backup Selections list

3 clients listed in the Clients list

Allow multiple data streams is selected

Max Jobs per Client value set to 4

How many jobs go Active when the job is started, excluding parent jobs?

An administrator must recover an expired image from a tape where only one remaining copy exists and there are other unexpired images on the tape.

How should the administrator ensure the image is retained?

Which information is validated during an image verification operation?

A NetBackup Master Server has commenced writing four long-running duplication jobs on an AdvancedDisk disk pool. The value of Maximum concurrent jobs for the storage unit and Limit I/O streams for the disk pool are both set to 4.

There are 35 jobs queued on the Master Server that require this disk pool:

    5 replication jobs with priority 9999

   10 backup jobs with priority 999

   20 duplication jobs with priority 99

Two restore jobs that require this disk pool are then submitted with default priority.

Which job type goes active next?

In the NetBackup Administration Console or Java console, how should an administrator change a disk pool to down status?

A storage unit group is configured that has disk and then tape listed. During a backup session, jobs start retrying and then running on the tape device only.

What is a likely cause of the change?

An administrator has backups failing with status code 96 due to tapes being prevented from returning to the scratch volume pool after the images they contain expire.

What prevented the media from returning to the scratch pool?

An administrator needs to back up 100 clients using 10 LTO5 tape drives.

Which policy setting will perform the backup fastest?