Weekend Sale - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 65percent

Welcome To DumpsPedia

HPE6-A72 Sample Questions Answers

Questions 4

Refer to the exhibit.

Which command produces the above output?

Options:

A.

show interface port 1/1/10 trunk

B.

show vlan port 1/1/10

C.

show trunk port 1/1/10 extended

D.

show interface port 1/1/10 switchport

Buy Now
Questions 5

Click on the colored box that corresponds with the line that best represents Unicast traffic flow.

Options:

Buy Now
Questions 6

What is the Link Layer Discovery Protocol?

Options:

A.

a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system

B.

a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4

C.

a standardized protocol for communicating directly-connected device information and capabilities.

D.

an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP

Buy Now
Questions 7

Refer to the exhibit.

What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the commandshow ip interface briefin the exhibit below?

Options:

A.

Access-1(config)# interface 1/1/1

Access-1(config-if)# routing

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

B.

Access-1(config)# interface 1/1/1

Access-1(config-if)# vlan trunk permit vlan 100

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address static 10.1.1.1/24

C.

Access-1(config)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

D.

Access-1(config-if)# vlan 100

Access-1(config-vlan)# ip address 10.1.1.1/24

Buy Now
Questions 8

What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)

Options:

A.

routing loops

B.

costs associated with upgrading from copper to fiber

C.

multiple frame copies leading to instability of the MAC address table

D.

security issues with a redundant loop indicating to hackers that a back-door exists

E.

broadcast storms

Buy Now
Questions 9

Review the exhibit.

Which ports should be configured as access ports? Click in the green box to make your selection. (Select two.)

Options:

Buy Now
Questions 10

Refer to the exhibit.

All four switches in the diagram have been configured with the region name "Aruba1".

What two other MSTP configurations must match for switches within the same MST region? (Choose two.)

Options:

A.

MST region type

B.

MST Bridge ID

C.

MST version number

D.

MST revision number

E.

MST VLAN to instance mapping

Buy Now
Questions 11

Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?

Options:

A.

Control and Provisioning of Wireless Access Points (CAPWAP)

B.

Generic Routing Encapsulation (GRE)

C.

Lightweight Access Point Protocol (LWAPP)

D.

Process Application Programming Interface (PAPI)

Buy Now
Questions 12

The customer has 778 developers testing computer games on the network.

Which two actions resolve Broadcast storms? (Choose two.)

Options:

A.

Manually disable the redundant link to immediately resolve the impacted portion of the network.

B.

Utilize Spanning Tree to dynamically disable all redundant links in a segment.

C.

Setting switch ports to half-duplex will resolve Broadcast storms using Carrier Sense Multiple-Access Collision Detection (CSMA/CD).

D.

Enable single Area Open Shortest Path First (OSPF) on all Layer 2 switches, but do not enable routing.

E.

Utilize Spanning Tree to dynamically block Designated ports in addition to Alternate ports.

Buy Now
Questions 13

Core(config)# user admin password

Core(config)# interface mgmt

Core(config-if-mgmt)# ip static 10.254.16.89/22

Core(config-if-mgmt)# default-gateway 10.254.19.129

Core(config)# ssh server vrf mgmt

Core(config)# https-server vrf mgmt

You are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings.

Which two steps are missing? (Choose two.)

Options:

A.

Core(config)# https-server rest access-mode read-write

B.

Core(config-if-mgmt)# no shutdown

C.

Core(config-if-mgmt)# no tftp-server

D.

Core(config-if-mgmt)# enable

E.

Core(config)# https-server rest access-mode read-only

Buy Now
Questions 14

Review the exhibit.

As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.

Click on the interface (circled in green) where the VLAN tag will be removed.

Options:

Buy Now
Questions 15

Refer to the exhibit.

The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports.

Which ports carry VLAN 1 traffic?

Options:

A.

1/1/8, 1/1/10, 1/1/5-1/1/24

B.

1/1/1-1/1/28

C.

1/1/1-1/1/24

D.

1/1/8-1/1/10, 1/1/5-1/1/28

Buy Now
Questions 16

Your customer has 349 users in a two-story building.

What are two benefits of a 2-Tier design? (Choose two.)

Options:

A.

Layer 2 and Layer 3 protocols run close to the endpoints to better implement ACL and QoS policy at the edge.

B.

Improved performance by offloading processing from the Access layer to the Core.

C.

Use of layer 2 switches at the access layer can process and route traffic from attached APs.

D.

Support for WAN/MPLS, Internet, and Data Center directly on the Collapsed core.

E.

Provides a more cost effective solution given that no additional switches are required for a third tier.

Buy Now
Questions 17

Refer to the exhibit.

The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches. What is the output of this command?

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Buy Now
Questions 18

Refer to the exhibit.

What is the correct binary conversion of the last two hexadecimal characters of the physical address?

Options:

A.

1101 1000

B.

1110 1101

C.

1001 1111 0101 0011

D.

1000 1101 1110 1101

Buy Now
Questions 19

You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.

What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

Options:

A.

checkpoint rollback 10

B.

checkpoint auto 10

C.

checkpoint auto confirm 10

D.

boot system secondary 10

Buy Now
Questions 20

What are two features of the three-tier designs? (Choose two.)

Options:

A.

removes the distribution layer in favor of a spine-leaf design used in modern data center deployments

B.

adds a distribution layer to free up resources from the Core for improved performance and routing throughput

C.

a more scalable design over by leveraging a distribution layer to handle Layer 3 routing and access control in large deployments

D.

uses only Layer 2 access on the Access and the Core with Layer 3 routing and access control provided at the distribution layer

E.

is considered legacy by requiring a large flat layer-two broadcast domain from Core to Access and should be avoided

Buy Now
Questions 21

Refer to the exhibit.

What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

Options:

A.

Use the command ping 10.1.1.254 vrf mgmt

B.

Use the command ping 10.1.1.254/24

C.

Change the Core-1 management address to 10.1.1.1/25 first

D.

The destination 10.1.1.254 requires configuring a static route

Buy Now
Questions 22

The section in blue can be ignored.

SW1(config)# interface 1/1/1-1/1/2

SW1(config-if-<1/1/1-1/1/2)# vlan access 2

SW1(config-if-<1/1/1-1/1/2)# exit

SW1(config)# interface 1/1/11-1/1/17

SW1(config-if-<1/1/11-1/1/17)# vlan access 17

SW1(config-if-<1/1/11-1/1/17)# exit

After completing the above commands, what is the expected output ofshow vlanwith no other vlan commanded having been added?

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Buy Now
Questions 23

Match each description to the correct term.

Options:

Buy Now
Questions 24

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

Options:

A.

Management interface split detection

B.

Peer switch-based detection

C.

Loopback keepalives

D.

ARP-based

E.

BFD

Buy Now
Questions 25

What command will save your configuration on an Aruba AOS-CX switch so that your changes automatically load on next reboot?

Options:

A.

copy running-config checkpoint startup-config

B.

copy startup-config running-config

C.

copy running-config initial-checkpoint

D.

copy running-config default

Buy Now
Questions 26

Refer to the exhibits.

The AOS-CX 6300M switch is attempting to configure VSF with a peer CX 6300F switch. What is one reason you are receiving the above error when attempting to configure VSF on the AOS-CX 6300M switch?

Options:

A.

AOS-CX VSF links can only be applied to uplink ports with 10G, 25G. and 50G speeds.

B.

VSF Is not possible between CX 6300M and CX 6300F AOS-CX switches.

C.

Link 1 cannot be used if the attached CX 6300F VSF member 2 has already assigned link 1

D.

The port1/1/21 has been shutdown

Buy Now
Questions 27

Match the term to the correct description.

Options:

Buy Now
Questions 28

With what other technology does Half Duplex communication closely match?

Options:

A.

a pair of fiber optic strands allowing transmit on one and receive on the other at the same time

B.

a mobile phone call

C.

point-to-point connections between two switches allowing concurrent transmit and receive

D.

CB radio using push-to-talk

Buy Now
Questions 29

Which two port characteristics must match between LAG interfaces? (Choose two.)

Options:

A.

Port number

B.

Duplex

C.

Member ID

D.

Media type

E.

Chassis number

Buy Now
Questions 30

Refer to the exhibit.

Switch-1 is not the root bridge. The ports shown are all the connected pointtopoint interfaces. What Role (hidden by the blue rectangle) will be assigned to theLag 1interface?

Options:

A.

Alternate

B.

Backup

C.

Root

D.

Designated

Buy Now
Questions 31

What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)

Options:

A.

VPN access

B.

WAN/MPLS connectivity

C.

Endpoint Access

D.

Deep packet inspection

E.

Power over Ethernet

Buy Now
Exam Code: HPE6-A72
Exam Name: Aruba Certified Switching Associate Exam
Last Update: Oct 9, 2024
Questions: 105
$56  $159.99
$42  $119.99
$35  $99.99
buy now HPE6-A72