A BGP finite state machine has the following states:
Active
OpenConfirm
Idle
Established
OpenSent
What is the state transition sequence to establish a successful BGP peer relationship?
What does the IP-prefix-filter "ip ip-prefix test index 10 deny 0.0.0.0 0 less-equal 32" mean?
Which of the following statements belong to BGP community attribute? (Select 3 answers)
If the subnet mask for Class A address is 255.255.240.0, how many bits are used for subnetting?
The ABR in a Totally Stubby area will not advertise Type-3, Type-4, and Type-5 LSAs into the Totally Stubby area. Instead, the ABR will advertise a default route to the Totally Stubby area enabling packet forwarding to other destinations.
Which of the following conditions must be met for importing routes into BGP using the network command? (Select 2 answers)
The route selection tool route-policy" can set and filter BGP attributes based on pre-defined conditions. Therefore, this tool is often used to define policies towards a BGP peer or during route generation.
Which of the following statements regarding the features of VLSM are true? (Select 2 answers)
IGMP interface group report information
Ethernet6/1/0(10.1.1.1):
Total 1 IGMP Group reported
Group: 225.0.0.1
Uptime: 00:09:03
Expires: 00:02:09
Last reporter: 10.1.1.30
Last-member-query-counter: 0
Last-member-query -timer-expiry: off
Group mode: exclude
Versionl-host-present-timer-expiry: off
Version2-host-present-timer-expiry: 00:02:09
The preceding information is generated after a router receives a Report message from group 225.0.0.1 through Ethernet 6/1/0. Which type of Report message will not be processed by the router?
Generally, the performance of an IP-prefix-filter is greater than that of an ACL.
Which of the following BGP attributes cannot be advertised to other neighboring AS?
If there are two BGP routes with the same destination address but different next hops in a BGP routing table, then which statement regarding the two BGP routes is true?
Which of the following is the address range assigned by IANA for SSM service in IPv4?
What are the differences between the IGMP versions 1, 2 & 3? (Select 2 answers)
Which statements regarding prerequisites to establish a BGP peer relationship are true? (Select 2 answers)
Which of the following statements are correct regarding BGP attributes? (Select 2 answers)
Assume that the subnet mask is 255.255.255.248. Which of the following are valid host addresses? (Select 3 answers)
Which of the following attributes must exist in the BGP update messages? (Select 3 answers)
Which of the following connection types can a Router LSA describe? (Select 3 answers)
An OSPF neighbor relationship fails to establish and the OSPF error information is displayed as follows. Which of the following is most likely the cause?
Which of the following situations will occur when the command "multicast bad balance" is
configured? (Select 3 answers)
Which of the following elements together uniquely identify a LSA? (Select 3 answers)
The ABR of an NSSA does not advertise Type-4 and Type-5 LSAs to an NSSA instead it imports external routes into the NSSA,
One route-policy may have several nodes with each node containing a node ID. Each node may also have multiple "if-match" and "apply" clauses. Which of the following statements are true? (Select 2 answers)
Which of the following messages needs to be sent out by a downstream interface when recovering from the pruned state to the forwarding state in PIM DM?
In VRP, by default, a BGP router does not automatically send a refresh packet to its BGP peers for retransmitting an Update packet after the inbound routing policy of the BGP peers changes.
Which of the following statements regarding multicast MAC addresses are true (Select 3 answers)
Which of the following routers have multicast routing entries even when there is no receiver on the network? (Select 2 answers)