Independence Day - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 65percent

Welcome To DumpsPedia

HPE6-A69 Sample Questions Answers

Questions 4

Refer to the exhibit.

A customer has implemented this ArubaOS-CX solution. NetEdit is not present. After a while, the secondary node of the VSX-cluster fails. What is the correct procedure to replace the failed node as quickly as possible?

Options:

A.

Replace the failed unit, boot up the new node without connecting cables, upgrade firmware and configure as secondary vsx node connect iSl and wart for VSX to synchronize After successful recovery, reconnect the remaining cables.

B.

Replace the failed unit, boot up the new node without connecting cables, upgrade firmware, and restore and save config Shutdown all ports, reconnect the correct cables, and enable all ports

C.

Replace the failed unit, connect the correct cables, boot up the new node in recovery mode, upgrade firmware and restore, and save config Then, reboot and wait for VSX to synchronize.

D.

Replace the failed unit, connect the correct cables, boot up the new node and wait for VSX to synchronize configuration and firmware.

Buy Now
Questions 5

What are two valid steps in a Proof of Concept plan? (Select two)

Options:

A.

Development of the items to Be tested

B.

Engineering a proposed solution

C.

Definition of success criteria

D.

Acceptance of the proposed solution

Buy Now
Questions 6

An administrator warns to create an ACL.

Permit traffic from 192.168.10, 65 through 192.168.10.94

Permit traffic from 192 168 10 104 through 192 16810.119

deny all other ip traffic

Which configuration is required to accomplish the administrator’s goals?

A)

B)

C)

D)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Buy Now
Questions 7

You have designed a new wired solution for a customer that uses gateways and Dynamic Segmentation Which statements about User-Based Tunneling are true? (Select two)

Options:

A.

In U8T, the switch performs user authentication.

B.

in UBT, the Aruba Gateway performs user authentication

C.

UBT is supported only with Aruba Gateway standalone

D.

in UBT, the switch sends user role Information to Aruba Gateway

E.

In UBT, the Aruba Gateway assigns the Primary user role

Buy Now
Questions 8

The customer is implementing new ArubaOS-CX 6300 switches into an environment that has third-party switches and uses centralized authentication from Microsoft Active Directory and TACACS* servers

What would be a valid configuration requirement for ArubaOS-CX switches for centralized user authentication?

Options:

A.

Importing a TACACS server certificate for TLS authentication into the switch

B.

Defining a TACACS server group for authentication in the switch configuration

C.

Enabling the active directory VSA in the switch for radius authentication

D.

Using a PAM extension for LDAP authentication with Active Directory Server.

Buy Now
Questions 9

You have removed a member out of the ArubaOS-CX 6300 VSF configuration. The login to the removed member falls. What is true about switch login recovery?

Options:

A.

The task requires physical access to the switch

B.

The zeroize task executes the zeroize.txt from the root of the CF card on the switch

C.

The zeroize task will remove all user passwords: the configuration remains on the switch

D.

The task can be executed remotely

Buy Now
Questions 10

A customer would like to utilize some ArubaOS-CX 6300F switches to perform OSPF routing.

With the ports set up as routed ports, and default parameters for OSPF. what is me OSPF cost for me connection between SW-3 and SW-4"?

Options:

A.

10

B.

100

C.

1000

D.

10000

Buy Now
Questions 11

Which statement is true regarding remote mirroring?

Options:

A.

The same source/destination address can be used in multiple sessions.

B.

Per session multiple destination addresses can be configured

C.

The ArubaOS-CX switch supports a maximum of two mirroring sessions

D.

When mirroring destination is tunnel, a DSCP value can be set on the tunnel

Buy Now
Questions 12

Refer to the following configuration:

How do you configure QoS policies for user traffic in conjunction with user roles in all wired access switches? (Select two)

Options:

A.

Use NetEdit to replicate the configuration of QoS policies to all wired switches

B.

in a RADIUS server with Aruba Vendor Specific Attribute (VSA) dictionary, you can add QoS policies for user roles.

C.

With ClearPass and downloadable user roles, you can add QoS policies for user roles

D.

QoS policies should be configured by the Mobility Controller when you need to set to all wired access switches

Buy Now
Questions 13

(Scenarios may contain multiple errors which may or may not Impact the solution)

Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration, it is required to implement Multi-Chassis Link Aggregation for each pair of switches

The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows:

There is an error message staling "incompatible interface." Which interfaces are the cause of the error? (Select two.)

Options:

A.

1/1/12 10GBaseT SFP*+ 30m Cat6A Transceiver

B.

1/1/49 40G QSFP+ 15m Active Optical Cable

C.

1/1/13 10GBaseT SFP+ 30m Cat6A Transceiver

D.

1/1/48 iGBaseT 100m Cat5e Transceiver

E.

1/1/50 40G QSFP+ 15m Active Optical Cable

Buy Now
Questions 14

A customer with an ArubaOS-CX 6300M switch is having a performance issue on the network and has received complaints about users experiencing intermittent connectivity. After performing troubleshooting it is determined that many of the local websites on the LAN that users are unable to reach are resolved to an invalid MAC address

What are the minimum steps that should be performed to mitigate this condition? (Select two.)

Options:

A.

implement dhcpv4-shooping.

B.

Implement ARP ACLs to define trusted MAC address to IP bindings

C.

Enable 'arp inspection’ on the end-user physical ports

D.

Enable 'arp inspection untrusted' on the end-user physical ports

E.

Enable 'arp inspection' on the end-user VLAN

Buy Now
Questions 15

(Scenarios may contain multiple errors which may or may not impact the solution )

Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer

The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

Options:

A.

Modify the system interface-group 4 speed tOg command change "25g" to "10g"

B.

Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing "vrf KA" to "vrf mgmt"

C.

Edit the vsx-sync command, adding "keep-alive"

D.

Modify the vsx definition, changing "inter-switch-link lag 2" to" inter-switch-link lag 256"

Buy Now
Questions 16

The example ACL is used with Aruba CX 6400 switches to permit traffic to web servers configured on interface 1/1/1 inbound with IP 10.254.4.1/24.

How does this ACL affect the HTTPS traffic to destination 10.254.4.7 from a client 10.253.1.5 via interface 1/1/2 with IP 10 254.3.1/24?

Options:

A.

The ACL would be valid only if bound to 1/1/2 outbound.

B.

The implicit rule allows the traffic

C.

The implicit rules deny the traffic.

D.

The traffic is allowed when ACL is Pound to inbound traffic.

Buy Now
Questions 17

Match the repotted status to the Aruba 8325 issue (Each option may Be used once more than once, or not at all)

Options:

Buy Now
Questions 18

ArubaOS-CX 8325 VSX configuration has a Tailed ISL link between the switches with keepalive status established. While troubleshooting the condition, what is the expected behavior of the VSX traffic flow in the current condition?

Options:

A.

vsx tables are n sync

B.

VSX tables are out of sync

C.

VSX nodes Keep forwarding traffic over its interfaces

D.

VSX protection state is OK

E.

VSX peer is seen as down

Buy Now
Exam Code: HPE6-A69
Exam Name: Aruba Certified Switching Expert Written Exam
Last Update: Jul 13, 2024
Questions: 60
$56  $159.99
$42  $119.99
$35  $99.99
buy now HPE6-A69