Refer to the exhibit.
The integrator is requested to validate a storage unit installation after the customer has done the self installation. What is the current health state of this customer's HPE MSA storage system? (Select two.)
Click on the area where a storage integrator can change a thick volume to a thin volume.
A storage integrator is validating an HPE 3PAR StoreServ implementation. The integrator created a volume in the HPE 3PAR StoreServ Management Console (SSMC) and needs to verify read/write access from a Linux operating system.
Which steps are part of the verification process? (Choose two.)
Which command can be used to display license information on an HPE StoreOnce system?
An HPE StoreVirtual 3200 system consists of 19x 1.2 TB Drives in a RAID5 with a capacity level of 75%. The network is built with four HPE FlexFabric 5900 switches.
The customer complained about performance challenges with the given configuration, and the administrator identified the drive configuration as a bottleneck. A performance analysis shows latencies above 60ms. Installation of the systems was done by best practices.
Which actions should be performed to solve these issues? (Choose two.)
A customer has HPE Data Protector and a StoreOnce VSA at a remote site that must replicate to the corporate data center StoreOnce backup device.
What considerations must be taken into account to allow for Catalyst replication?
Refer to the exhibit.
A customer complains of poor performance on an HPE MSA 2040 storage array. The storage administrator thinks that the host ports could be limiting factor because only two ports are connected to the SAN fabric. To verify this the administrator wants to use the performance monitor of the MSA system, but has never used this monitor before. The administrator logs on to a HPE MSA 2040 in the lab to get familiar with performance monitoring.
Which value would indicate a host port performance issue?