Refer to the exhibit.
Starting in the upper left corner of the SCv3000 what is the numerical order of the disks across the top row? A. 3, 2, 1, 0
B. 4, 3, 2, 1
C. 1, 2, 3, 4
D. 0, 1, 2, 3
A customer wants to have the SED feature enabled through Dell Storage Manager (DSM) 2016 R2. How is encryption enabled on the SED?
A customer wants to add an iSCSI path to a Microsoft Windows Server 2012 R1. The server has an existing Fibre Channel path to an SC7020 array for load balancing and high availability.
Which Windows MPIO policy should be configured to achieve the customer’s requirement?
Which Live Volume Requirement or Best Practice is necessary for disaster recovery?
A company is using an SC4020 array and the storage administrator wants to expand the available capacity by adding 92, 3.5” disk drives. Which expansion enclosure(s) can be used to meet the demand?
You have implemented two SC Series systems at a customer site. The Dell Storage Manager (DSM) Suite has been installed on a Microsoft Windows server. Both Storage Centers have been installed and added to the DSM. However, several days after the installation, the customer is only able to see one Storage Center in the DSM GUI.
Which recommended action will correct this issue?
Based on the exhibit, a customer is using Virtual Port Mode. If the primary path for the controller on the “left” is disconnected while running an IOmeter test for a volume owned by the “left” controller, will the system survive failover?
Which best practices should be followed when using iSCSI to connect SC Series arrays and hosts?
Which 64-bit server operating systems are compatible with the Dell Storage Manager (DSM) Client?
You are deploying a new SCv2020 system with four additional SCv100 expansion enclosures. What is the spare-to-managed drive ratio?
A customer notices a volume is using an above average amount of Tier 1 RAID 10 space. What can be done to force this data into a lower RAID set/Tier?
What is the name of the out-of-band system management connection for SC9000 systems?
What is the correct sequence of steps to enable MPIO on a Microsoft Windows 2012 Server?
You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches. What is the minimum number of port(s), per switch, that can be used by the SC Series array?
The SC configuration consists of a SC7020, two (2) FC switches and four (4) Servers with a dual port FC HBA. How many zones are required for the SC to run with virtual port mode enabled?
What is used for migrating data from legacy system volumes to SC default provisioned volumes?