dumpspedia logo
Refer to the exhibit.
You have created a Distributed Device in a VPLEX Metro. You want to confirm you have chosen the correct volumes before performing a device mobility job within cluster-2. Which object will be the source for this operation?
What are the recommended protection and disk type when selecting a VPLEX Logging Volume?
A host attempted a read from a volume in a VPLEX Metro configuration. The data does not exist in cache at all.
What process does VPLEX use to service the read request?
Refer to the exhibit.
NDU pre-check failed because minimal topology is in use. Which parameter can be added to the ndu start command that will allow the NDU to proceed without error in this situation?
Which vplexcli command will ensure that the directors SSD firmware has been upgraded to the correct version after the VPLEX NDU?
A customer has a VPLEX Metro installed. They asked you to recommend a method to non-disruptively move Virtual Volumes from a storage array at Cluster 1 to a storage array at Cluster 2. What would you recommend?
Refer to the exhibit.
A customer needs to provision storage to a host on Cluster 1, but there is no additional local array capacity to allocate. How could the customer facilitate assigning storage to the Cluster 1 host from an array locally connected to Cluster 2?
A customer wants to add a mirror to a VPLEX Local RAID-0 device.
Which RAID type is created after the command "device attach-mirror"?
You created a synchronous consistency group, which contains two distributed volumes configured with the rule "set cluster-1-detaches".
What is the expected behavior of the virtual volumes in the event of a WAN-COM failure?
What is an EMC best practice for fault tolerance when zoning a VPLEX Metro together over Fibre Channel for successful communication between the sites?
When configuring a VPLEX local cluster, according to EMC best practices, how many metadata volumes are required?
You are preparing a site for a large Metro VPLEX cluster. The storage administrator wants to prepare the storage network configuration and needs to ensure easy troubleshooting of storage path faults.
How many WAN-COM zones per fabric will need to be created?
Refer to the exhibit.
You are preparing to perform an upgrade on an unconfigured VPLEX Metro. When you run the ndu pre-check command, it indicates that it has failed and there are no first upgraders. In your troubleshooting, you run the version -a command.
Based on the output, what is the reason for the failure?
What are the three components that a drill-down command can be run against to provide a more detailed analysis?
In a customer's VPLEX Metro environment, a host has been provisioned as a single virtual volume from cluster-1. The customer now needs to convert the local virtual volume to a distributed device.
How can the customer accomplish this?
Which type of statistics is used to track latencies, determine median, mode, percentiles, minimums and maximums?
What should be the maximum latency between a VPLEX Management Server and the Cluster Witness?
A customer has ordered a two-engine VPLEX cluster to be installed in a custom rack. A minimal VNX5300 is already installed in the middle of the rack, occupying nine rack unit spaces.
What is the correct approach to deploy the two-engine VPLEX cluster?
A customer is moving some VMAX devices under a VPLEX Local and is using PowerPath as multipath software.
What is the SCSI product ID assigned to VPLEX volumes?
In a customer's VPLEX Metro environment, a host has been provisioned as a single virtual volume from cluster-1. The customer now needs to convert the local virtual volume to a distributed device.
How can the customer accomplish this?
Refer to the exhibit.
You are planning to perform data mobility between VPLEX Clusters using the GUI. What mobility job options do you have?
TESTED 06 May 2024
