According to Huawei’s CloudFabric intelligent O & M description, the health model is built as a multi-dimensional evaluation system that assesses the network from five dimensions: device, network, protocol, overlay, and service . This means every option listed in the question is part of the CloudFabric health model. Huawei explains that this model integrates telemetry-assisted data such as configuration data, forwarding entry data, logs, and KPI performance information, allowing the platform to detect faults and risks in real time across these five layers.

In practical Huawei CloudFabric operations, the device layer focuses on node health, hardware state, and resource status; the network layer checks connectivity and path quality; the protocol layer verifies control-plane protocols and convergence behavior; the overlay layer evaluates virtualized forwarding networks such as VXLAN fabrics; and the service layer measures the actual service experience and traffic exchange status. Huawei explicitly presents these five as the full health-evaluation scope of CloudFabric intelligent O & M, so the correct response is all five options

In Huawei networking, Eth-Trunk (link aggregation) can operate in two modes: manual mode and LACP mode . In manual mode , the Eth-Trunk is statically configured by the administrator, and member interfaces are manually added without using the Link Aggregation Control Protocol (LACP) .

In this mode, all member links that are up are considered active by default , and they simultaneously participate in traffic forwarding and load balancing . Traffic distribution is typically based on hash algorithms (e.g., source/destination MAC or IP), ensuring efficient utilization of available bandwidth.

Unlike LACP mode, manual mode does not perform dynamic negotiation or link state detection between devices. Therefore, it requires consistent configuration on both ends to avoid issues such as loops or traffic blackholing. However, it is simpler and can be useful in controlled environments.

In Huawei data center designs, especially in M-LAG scenarios , LACP is generally preferred for better reliability and fault detection. Still, the statement accurately describes manual mode behavior.

Therefore, the statement is TRUE .

In Huawei CloudFabric architecture, logical switches are a key abstraction used to simplify network service deployment and management. These logical switches are built on top of VXLAN Layer 2 networks and represent virtualized broadcast domains (similar to VLANs, but more scalable).

Huawei extends the function of these logical switches by integrating distributed Layer 3 gateway capabilities directly into them. This means that each logical switch can provide both Layer 2 connectivity and Layer 3 routing services (commonly referred to as distributed gateways). These gateways are typically implemented on leaf nodes using VXLAN with BGP EVPN as the control plane.

As a result, traffic between subnets can be routed locally at the ingress leaf switch without needing to traverse to a centralized gateway, significantly improving efficiency and reducing latency. Logical ports connected to these logical switches automatically receive gateway services, enabling seamless inter-subnet communication.

This design aligns with Huawei’s intent of decoupling physical and logical networks while providing scalable, agile, and highly efficient data center networking. Therefore, the statement is TRUE.